Comparison of fire protection materials in bridges and power industry
Fire blocking, these four words, although it seems very simple, but it contains a lot of knowledge, and, so far, has not reached the full extent, so based on this, the following will Continue to carry out its work so that everyone can have learning content, and then, can also promote the learning process of the product.
1. In the power industry, if there is fire blocking, then what are the practices?
In the power industry, if there is fire blocking, then there are two main methods, one is to use traditional fireproof materials for sealing, such as organic and inorganic blocking materials, and fireproof coatings. The second is to use some new aerogel fireproof materials for sealing.
2. Fireproof sealing on the bridge, is there any specific requirements in the specific operation?
The fireproof plugging on the bridge has some corresponding requirements in terms of specific operations. Therefore, the answer to this question is yes, and this is also no doubt. If, specifically, it is: the distance between the ceiling and the fire tube should not be less than 100mm. The upper part should be sealed with an aerogel fireproof board. If the requirements are not high, it can also be a soft smokeproof material.
3. Aluminum veneer, can it be used as a fireproof sealing material? In addition, the fireproof sealing of the pipeline through the floor, which material is relatively expensive?
Aluminum veneers cannot meet fire protection requirements because of their low melting temperature. Therefore, it cannot be used as a fireproof sealing material for fireproof sealing. The fireproof sealing of the pipeline through the floor, the material with relatively high cost is the aerogel fireproof coating board, and its quality is also very good, and can have good fireproof effect.